The Rosin Tech mold is used to cold press the buds before pressing them in the rosin press.
With this technique we managed to make a pressed grass brick.
This way we avoid the appearance of air pockets where the Rosin is retained when hot pressing.
In addition, we will be able to press more grass in the same bag than if we did not press it.
Another advantage of doing a cold pressing is that we avoid the bursting of the bags.
Thanks to using the mold we can increase the performance of each Rosin bag by up to 20%.
The mold opens both at the top and at the bottom so that the brick can be easily removed after cold pressing.
Normally the grass is pressed without a bag to obtain a perfect brick.
Then we will take this brick and put it in a filter bag or tea bag with which we will finally press it hot.
Remember to pick a non-stick paper of quality to be able to collect the resulting resin without it sticking everywhere.
What measures does the Rosin Tech mold have?
- 24,4 x 6,7cm. (23,5 x 5,7 cm. inside)
- 12 x 7,6cm. (11 x 4 cm. inside)
- 7,5 cm x 5 cm.
What material is it made of?
The small mold (7,5 x 5 cm.) is made of hard ABS plastic.
The other 2 models are made of anodized aluminum with a black finish.
Discover how to make rosin Like the pros with our step-by-step guide and a few tricks.
You can check here the description on the official page of Rosin Tech.
Ratings
Not yet reviewed