El automatic water pH controller de Prosystem Aqua Kontrol01 has been designed for the continuous control and measurement of pH in irrigation reservoirs.
The flow rate of the pH regulating liquid is 40 ml/h, which allows you to adjust the pH level of the tank water from a value that you indicate to which you want to have the pH.
Furthermore, the regulating pump or water pH controller It comes equipped with a complete installation kit that includes:
- pH electrode
- Suction and discharge fittings
- Suction and discharge pipes
- Calibration bottle 50ml pH7
- Wall fixing bracket
- Bats
- fixing screws
- Float for pH probe.
Automatic pH controller Aqua system: Steps to follow to install the regulating pump
- Switching on the pump: Once installed and connected to power, we will proceed to the programming of the pump. We will indicate the value that we want to obtain in the water (set point) and then we will program the mode in which we want the pump to act, pH down mode (acid) or pH Up mode (alkaline). Check that the probe is calibrated, if not, proceed to calibration.
- pH measurement: The probe detects the pH level of the water and is indicated on the pump display.
- pH Down or pH up suction: The pump sucks from the pH down or pH up bottle through the suction filter.
- Product injection: The pump injects the pH down or pH up liquid through the injection valve.
- PH adjusted: The pH regulation product is injected by the pump and mixed by the recirculation pump until the pH probe detects the pH value programmed in the pump in the water, and stops dosing.
The pump can work both with a lower pH and with a higher pH.
Remember that each regulation pump includes the Instructions for use and maintenance.
If you want to consult some more technical detail you can see the product in the official page of the manufacturer.
Ratings
Not yet reviewed