The Quest 70 Aerial dehumidifier is a compact but highly efficient model.
With a consumption of only 680 W, it manages to eliminate up to 33 liters of water per day inside the culture room.
Its assembly is usually done in the upper part of the growing room and thus does not take up space for the plants.
Although it can also be used on the ground but always without obstructing the air inlet and outlet.
Keep a space of 30 cm. free around the air inlet and outlet.
The Quest 70 features a built-in control, as well as the ability to connect a mounted remote control to the unit.
The control must be located in an area where the control can accurately sense the humidity of the area where it is desired to control it.
If the Quest 70 is located outside of the area where humidity control is desired, it is advisable to use a wired remote humidity control in order to achieve correct measurement.
When using the wired remote dehumidifier, make sure the built-in dehumidistat is in the off position by turning it counterclockwise until it stops.
If this is not done, the unit may detect the moisture in the wrong area.
What sets this dehumidifier apart from the rest?
- Great capacity
- MERV-13 Filtration
- low temperature operation
- low voltage control
- carbon filtration
- Optional Equipment
– Duct kit
– Hanging kit
– set of wheels
– Condensate pump
Characteristics of the Aerial Quest 70 dehumidifier
- Power: 460 W
- Consumption: 5.1 A
- Dehumidification capacity: 26 liters per day.
- Efficiency: 2,8 liters /KWh
- Measurements: 53,3 x 30,5 x 30,5 cm.
- Weight: 24,94 kg.
Ratings
Not yet reviewed