The 100 l/h adjustable dripper will allow us to create automatic irrigation in our crop in a simple way.
This type of dropper has two ways to connect it; punctured in a general irrigation pipe or with a 4-7 mm microtube.
The green top cap screws onto the base to have more or less water flow for a better fit.
Not all the plants on the same irrigation line need the same amount of irrigation, so we can adjust different flow rates within the same line without any problem.
Thanks to the size of its holes we will avoid obstruction due to the salts that may remain from our fertilizers.
It is recommended the preventive use of Duct and Substrate Cleaners, in order to avoid possible blockages caused by these salts.
You have all the necessary material to automate your irrigation in our section of pumps, tanks and drippers.
Characteristics of the adjustable dripper:
- 8 exit holes of 2 mm.
- Connector for 4/7 mm tube.
- Adjustable flow.
Growlet tip:
It is advisable to use an irrigation pump greater than the needs of our irrigation circuit.
In this way we can adjust the pressure and flow of the drippers, as well as prevent possible expansions.
Ratings
Not yet reviewed