El ProsystemAqua Ec Automatic Controller It comes equipped with a very complete and easy-to-use installation kit.
Inside the packaging you will find different elements that you must connect following the instructions for use.
What does the ProsystemAqua Ec Automatic Controller include?
- 1. Conductivity probe.
- 2. Connector cable for Ec probe.
- 3. Suction and delivery fittings.
- 4. Suction and delivery tubes.
- 5. Holding square.
- 6. Screws for fixing.
- 7. Instructions for use manual.
To start working with the automatic Ec controller you have to follow these steps:
- Switching on the pump: Once the pump is installed and connected to power, proceed to the programming of the pump. Indicating the value of EC in the pump that we want to obtain in the water. Later we will perform a calibration of the EC probe.
- Water recirculation: The water recirculation pump must be working at the same time as the EC pump and recirculating the water through the collector, which we have previously installed with the EC probe and the pump injector.
- Conductivity measurement: The EC probe detects the conductivity in the water tank and is indicated on the pump display
- Fertilizer aspiration: The pump sucks from the fertilizer mixture bottle that we have prepared and through the suction filter.
- Fertilizer injection: The EC regulating pump doses fertilizer through the manifold injection valve until the EC value that we have programmed in the pump is reached in the water tank.
You can see this and more articles on the website ProsystemAqua
Ratings
Not yet reviewed